SY777 - Create and Clear Memory Crash Procedures

SY777 - Create and Clear Memory Crash Procedures

1. Clear Memory Crash 

      Step 1.  Press 6 times on the 0  key.           
                    An asterisk appears for each time that this key is pressed.

      Step 2.  Press once on the Enter key.

      Step 3.  Press 3 times on the Arrow UP key next to display.

      Step 4.  Press 2 times on the Arrow Down key next to display.

      Step 5.  Press 3 times on the Arrow UP key next to display.
                    The message CLEAR MEMORY? will appear on the display.

      Step 6.  Press 1 time on the Arrow Down key next to display.           
                   The message MEMORY CLEARED will appear on the display.

                   This will cause the terminal to enter the technician mode.

                  Press Enter key to cycle through all the functions until the screen says “No Prog”
Please make sure Polling is set N & Network Card set to B when cycling through the functions..
      Step 7. Re-program the terminal from Software.

2. Create Memory Crash


     Step 1.  Disconnect the terminal from the power source.

      Step 2.  Move J3 to pins 2 and 3.

     Step 3.  Connect to the reconnect to the power source.

     Step 4.  Disconnect from the power  source.

     Step 5.  Move J3 to pins 1 and 2; memory crash occurs

     Step 6.  When memory crashes, the following message is displayed: CRASH



    • Related Articles

    • SY745 - Create and Clear Memory Crash Procedures

      1. Clear Memory Crash       Step 1: Press 6 times on the 0 key.                    An asterisk appears for each time that this key is pressed.       Step 2: Press on the Enter key once.       Step 3: Press 3 times on the line up key. (Next to the ...

    • SY780 - Create and Clear Memory Crash Procedures

      1. Clear Memory Crash        Step 1: Press 6 times on the 0 key.                     An asterisk appears for each time that this key is pressed.       Step 2: Press once on the Enter key.       Step 3: Press 3 times on the line up key.       Step 4: ...

    • SY785 - Create and Clear Memory Crash Procedures

      1. Clear Memory Crash       Step 1.  Press 6 times on the 0  key.                      Asterisk appears for each time that this key is pressed.       Step 2.  Press once on the Enter key.       Step 3.  Press 3 times on the UP key.       Step 4.  ...

    • SY711 to SY715 - Create and Clear Memory Crash Procedures

      1. Clear Memory Crash        Step 1.  Press 6 times on the F2 key (SY711) or the 0 key (SY715).                     An asterisk will appear for each time that this key is pressed.       Step 2.  Press once on the F4 key (SY711) or the ENTER key ...

    • How to sync an employee to SY910

      If you have made any changes to an employees templates on the Synel platform (such as adding pin so they use that instead of face recognition) then the following must be done to sync the employee to the device and the Synel platform. 1. Log into the ...