SY745 - Create and Clear Memory Crash Procedures

SY745 - Create and Clear Memory Crash Procedures

1. Clear Memory Crash

      Step 1: Press 6 times on the 0 key.
                   An asterisk appears for each time that this key is pressed.

      Step 2: Press on the Enter key once.

      Step 3: Press 3 times on the line up key. (Next to the display on right hand side)

      Step 4: Press twice on the line down key. (Next to the display on right hand side)

      Step 5: Press 3 times on the line up key. (Next to the display on right hand side)
                  The message “CLEAR MEMORY?” will appear on the display.

      Step 6: Press once on the line down key. (Next to the display on right hand side)

      Step 7: The message MEMORY CLEARED will appear on the display.

      Step 8: You receive a NO PROG display. 

      Step 9: Program the terminal using Software.

2. Create Memory Crash

      Step 1: Unplug the terminal and make sure that it is off. The back-up battery automatically supplies power for approx. 15 seconds.

      Step 2: Unscrew and remove the front panel.

      Step 3: Remove the JP4 jumper from the 1-2 position to 2-3 position.

      Step 4: Reposition JP4 to (1-2).

      Step 5: Plug the terminal back into a power source and make sure that MEM CRASH reappears in the terminal display
.



    • Related Articles

    • SY777 - Create and Clear Memory Crash Procedures

      1. Clear Memory Crash        Step 1.  Press 6 times on the 0  key.                                An asterisk appears for each time that this key is pressed.       Step 2.  Press once on the Enter key.       Step 3.  Press 3 times on the Arrow UP key ...

    • SY780 - Create and Clear Memory Crash Procedures

      1. Clear Memory Crash        Step 1: Press 6 times on the 0 key.                     An asterisk appears for each time that this key is pressed.       Step 2: Press once on the Enter key.       Step 3: Press 3 times on the line up key.       Step 4: ...

    • SY785 - Create and Clear Memory Crash Procedures

      1. Clear Memory Crash       Step 1.  Press 6 times on the 0  key.                      Asterisk appears for each time that this key is pressed.       Step 2.  Press once on the Enter key.       Step 3.  Press 3 times on the UP key.       Step 4.  ...

    • SY711 to SY715 - Create and Clear Memory Crash Procedures

      1. Clear Memory Crash        Step 1.  Press 6 times on the F2 key (SY711) or the 0 key (SY715).                     An asterisk will appear for each time that this key is pressed.       Step 2.  Press once on the F4 key (SY711) or the ENTER key ...

    • How to sync an employee to SY910

      If you have made any changes to an employees templates on the Synel platform (such as adding pin so they use that instead of face recognition) then the following must be done to sync the employee to the device and the Synel platform. 1. Log into the ...