SY 910 Face with Mifare cards

SY 910 Face with Mifare cards

Go to Setting → Advanced → ICID Card Type and change ID Format to Synel 13 bit.

Once it is done the Mifare card number detected by SY910 should match the number read by USB enrollers.


    • Related Articles

    • TLW - SY Face 910 Webservice Firmware Error Table

      If the clock Just says "Error" when you swipe nothing more check that the device has been added to the Syserverdll config file,  otherwise see table bellow. 16 July 2018 17:29 All,   Note that the SY910 devices have now new message wording as follow. ...

    • Suprema Bioentry wont react to cards presented

      When using cards with the Bioentry readers the card presented did not register on the event screen and the door did not react. Solution : Check using Biostar software for 2 settings Byte Type to be set as LSB not MSB Verification method to be set to ...

    • SY910 Error on swipe online

      Synergy Face 910 Red Error on Swipe Online If the clock registers as Online with the network icon in the top left but every time you swipe you get this error. Check that the 10 Digit Buffer has been activated in the device definitions

    • Absence Request Email Notification process TimelogWEB / Synergy WOrkforce

      Absence Request Email Notification Process If Employee is set up with Absence manager and Deputy Manager                       Note - Absence can be approved or rejected by any one manager.  If Employee is set up with Absence manager 1 and Absence ...

    • Absence Hours to Cost Centre Report

      Absence Hours to Cost Centre Report Issue reported: Even though the devices are allocated with Cost Centres, the Absences booked by the employees are not calculated on the Cost centre report. Solution: Allocate employees against cost centre on the ...