Connecting Synergy A using TPLink 4G Router with SIM

Connecting Synergy A using TPLink 4G Router with SIM


Connecting Synergy A using 4G Router with SIM




4G Router Setup 


  1. You will have to insert the activated Sim to the router.
  2. Connect the router to your laptop through Wifi, Router name and password will be there at the back of the router. 
  3. Once it is connected, use the link http://tplinkmodem.net, it will ask you to enter the password, Use Admin and then log in.
  4. We will have to register the Sim to the router, click on Quick set up tab => Select the correct time zone=>the dial up page will show the ISP information of the sim card, register the sim to right network.
  5. Once the connection is successful, the device should come online, try pinging the device.
  6. The router should show all the signals (as sown in the screen shot) 




    • Related Articles

    • Absence Request Email Notification process TimelogWEB / Synergy WOrkforce

      Absence Request Email Notification Process If Employee is set up with Absence manager and Deputy Manager                       Note - Absence can be approved or rejected by any one manager.  If Employee is set up with Absence manager 1 and Absence ...

    • Finding Biostar Device Mac address using Serial Number

      Finding Biostar Device Mac address using Serial Number. If you would like to find the device’s IP based on the MAC address you can follow the steps below. 1.Check your device ID written on the device label on the back of the device. 2.Change the ...

    • Absence Hours to Cost Centre Report

      Absence Hours to Cost Centre Report Issue reported: Even though the devices are allocated with Cost Centres, the Absences booked by the employees are not calculated on the Cost centre report. Solution: Allocate employees against cost centre on the ...

    • Suprema Bioentry wont react to cards presented

      When using cards with the Bioentry readers the card presented did not register on the event screen and the door did not react. Solution : Check using Biostar software for 2 settings Byte Type to be set as LSB not MSB Verification method to be set to ...

    • Fire Report by Building

      Synergy Workforce Fire Report by Building With the latest of v4.0.0.0 patch roll out this week, Fire report triggered by Adam Fire Link will contain the Building name in the Subject and Body of the email address and the report as well See ...